Lost all audio.

[Blargh72]

This morning I purchased a few drumkits(BrandNuMetal 24 bit, and NuMetal II), then I put the files in my drummer folder. When I started up Riffworks(Line6edition 2.10.0, build 2710) a window came up telling me to log in to activate my new kits... when I did I recieved an error message(cant remember what it was specifically), and before I could save a diagnostic file the program crashed. Now when I boot up Riffworks I get no audio whatsoever, my previous songs make no sound, and no drumkits work at all. The signal is still working as I can see the signal meters at the top of the screen bouncing away... so what gives? Everything was fine up until this point. Any ideas or help would be much appreciated, thanks

Chris

[Blargh72]

I think I may have found the problem... when I click the Audio setup button, my ASIO device and Output channel fields are blank. What the....?? Would a re-installation be my best option at this point? I'm not sure what goes in those fields.

[camaro24gold]

Hi Blargh72

Go into your Sound And Audio Devices control panel and set it for whatever Line6 device you are using. Hopefully maybe something simple like that will do the trick and was what messed up on you during the crash.
I have had occasions where the audio stopped and actted like you are saying and a simple reboot of the computer usually fixes it.
Good Luck

[camaro24gold]

ok...just saw your 2nd post.
Run the Monkey maybe to see what it says about your drivers.

[Blargh72]

Thanks Camaro, the reboot worked! *wheeeeewwwwwww* Hows that for a simple solution... pardon me while I slap myself in the face for not trying it before ;o)

[camaro24gold]

Very cool

[Wedgebill]

You can try unpluging and repluging the USB lead that works with my PODXT Live