Using lightsnake with riffworks.
Moderators: gatorjj, JouniL, scott, bluesydude, mickeymix, Wedgebill
3 posts
• Page 1 of 1
by Guitarshredin101 » Wed Aug 08, 2007 6:07 pm
has any one tried using a lightsnake to record on riffworks. because i am having trouble recording with my lightsnake and i am looking for any suggestions from someone that might know why or has had the same problem so please give me some help so i can start to record.
- Guitarshredin101
- New member
- Posts: 1
- Joined: Sat Jul 28, 2007 4:18 am
by scott » Wed Aug 08, 2007 7:02 pm
I'm assuming the Lightsnake will somehow direct the audio signal through your computer's soundcard. You'll need to make sure RiffWorks has that card set as it's ASIO device. You should then be able to use Amplitube to model your signal.
- scott
- Member
- Posts: 3455
- Joined: Fri May 06, 2005 5:58 pm
- Location: Scotland
by Hayden » Wed Aug 08, 2007 9:04 pm
Hey guys,
The problem is that the lightsnake does not currently have an ASIO driver available. So we were talking with Guitarshredin101 about trying to use ASIO4ALL without our official support on the matter. Since we, of course, do not officially support ASIO4ALL. However, he hasn't been able to get the lightsnake to record audio using that method.
So if anyone has had any success with the lightsnake, please chime in.
The problem is that the lightsnake does not currently have an ASIO driver available. So we were talking with Guitarshredin101 about trying to use ASIO4ALL without our official support on the matter. Since we, of course, do not officially support ASIO4ALL. However, he hasn't been able to get the lightsnake to record audio using that method.
So if anyone has had any success with the lightsnake, please chime in.
- Hayden
- Member
- Posts: 224
- Joined: Tue Mar 06, 2007 8:37 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest