Sonoma Wire Works - Support Forums

by **Kaizu77** » Sun Dec 21, 2008 12:02 pm

Hello folks!

I wonder if anyone out there has used Sonar 7 as a ReWire slave for RiffWorks, or happens to know if it's even possible.
I'm using RiffWorks Standard with my Boss-gt10 now (a presonus inspire will be arriving soon).
So far, I haven't even managed to get both programs find the gt10 when run simultaneously. I undertand this could be a boss driver/interface-related issue, but it would be cool to know if someone has had similar experiences or could share some useful information about Sonar/Rewire.

The Best of Holidays for all!

k

by **atalwar** » Sun Dec 21, 2008 11:34 pm

i Dont think you can run Sonar as a slave. but again you might need to hunt and confirm thar in cakewalk forums or support if at all sonar can run as slave.

All these Big Daw's Don't like to run slaves but as Masters ,exception being ableton live ,but then it ain't a complete Daw either.

by **Rotund** » Mon Dec 22, 2008 2:38 am

Sonar runs as a master and not a slave.

by **Kaizu77** » Mon Dec 22, 2008 7:16 pm

That's what i was slightly afraid of... I'll come up with something else then...

Thanks for your answers!

k

by **blue4u** » Mon Dec 22, 2008 9:50 pm

What about Reaper? Seems to work ok?

by **JOHNNYMORGAN** » Wed Feb 25, 2009 12:56 pm

Hi I just sent you an email asking how you use Riffworks with the GT10. As a matter of interest, I have used Reason as a Rewire device with Rifftracker and it worked fine.

Best Regards

John M

Sonoma Wire Works - Support Forums

Cakewalk Sonar 7 as ReWire slave - experiences?

Who is online